Hello,


I had bought Atmel's RF4CE-EK kit.
which contains 1 STB, 2 RCB(Atmega256RFR2), 1 Key control board.

I had setup USB driver, install Boot loader.

When 1st time it connect to PC via USB it shows some menu in Tera-Term like start and setup etc.

Then for install application i had load that basic .srec file in both module of RCB As per it's document, and what, problem start from here, It doesn't showing me menu which i had seen 1st time.

Main problem is that every where and in every document i had seen that with this RF4CE-EK kit they provide Atmega128RFR2 and i got Atmega256RFR2 RCB board.

So Can anybody help me with proper guidance which file have to set up and how with this different module?


Thanx in Advance

Regards Kalpesh.